• Purchase SolidCAM with iMachining!

    Fill out the form to the right to purchase SolidCAM with iMachining at our best deal of the year.

    Save $500 - $1,000 on All Systems
    with our IMTS Special!*

    from now until September 20th, 2012

    *Not valid on upgrades, educational or research sales.

    SolidCAM’s iMachining cuts faster to dramatically decrease your cycle times while improving your tool life, and we’ll prove it! If we don’t cut your cycle times in half, we’ll refund your money within a week - GUARANTEED!

    • Reduced cycle times
    • Longer tool life
    • Automatic Feeds and Speeds
    • Reduced programming time
    • Morphing spirals
    • Intelligent separation
    • Best user interface

  • Complete the form below to purchase SolidCAM with iMachining at our lowest price of the year, and be automatically entered for a chance to win the custom SolidCAM Honda CRF250X!

    Contact data
    Details

Here's what our Customers have to say ...

  • "Just ran our first part cutting steel took about 5 min using iMachining compared to the 2-3 hrs we were spending before to make the same part."
    - Rob Montgomery | Mechanical Products, USA

    “We have found all the claims for iMachining to hold true for our applications in Dixon Surgical - incredible tool life, faster cycles, lighter cutting loads reducing vibration in poor workholding situations (mill-turn), and protection of small diameter cutters. The user interface is very clear and simple, and programming iMachining is faster than traditional strategies.”
    - Jay Dixon | Dixons Surgical, UK

  • "We tried pretty hard to destroy the endmill, but it looked like new when we were done.”
    - Jake Aasness | Kline Oilfield, USA

    "Watching a machining operation for the first time is an adventure similar to the 'Reno Air Races', without the crash. We have been running an aluminum pocketing job on Fadals for 15 years. The run time has been 22 minutes. Typical chirping in the corners; motor red-lining in the corners. The job now runs in 9 minutes, and the motor never exceeds 40%, and I have not worn a tool yet in three days of cutting (1/2" EM 2" LOC)."
    - Greg Burns | Burns Machinery, Inc., USA